Arch openings problem

[Anonymous]

I have a problem using the arch-window opening
The default arch-window use a semi-circle as an arch but this ,if the window is to long,make the window higher than the host wall.
I also try the ellipse window but i have the same problem
Is there an arch-window that use an arch smaller than the semi-circle of the standard window
Thanx

[Anonymous]

Do you mean like this, in Door and Window Builder, where the arch is not tangential at the sides?

[Anonymous]

Yes ,this is ,but a don't have window door builder what can i do???

[Anonymous]

Miker here is a Screen Shot I had saved for a Different Post back in Dec. 2005. W Eyebrow Fix.

Also Check out this Post, also.

Note: I do not recommend the SE Library.

[Anonymous]

Thanks for the replies but i want an empty opening and not a window.

[Scott Bulmer]

Miker,
You most likely already know this, but use SEO for a hole or if you need an empty opening with a frame make a custom window easily done in AC9. Hope that's what you're looking for.
Scott

[Anonymous]

If i don't find anything else i 'll do it the easy way.
Thanks anyway

[Djordje]

miker wrote:
Thanks for the replies but i want an empty opening and not a window.

Draw the slab of the required shape, set its ID to wallhole, save as a window.

[Scott Bulmer]

Djordje wrote:

Draw the slab of the required shape, set its ID to wallhole, save as a window.

Thanks Djordje; that info is huge!
S

[Anonymous]

Scott wrote:
Djordje wrote:

Draw the slab of the required shape, set its ID to wallhole, save as a window.

Thanks Djordje; that info is huge!
S

Additionaly you can use as ID the "Wallniche"
It cut a piece from a wall not a through out hole