Cut fills and beams that melt together
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2013-12-15
08:00 AM
- last edited on
2023-05-26
12:28 PM
by
Rubia Torres
2013-12-15
08:00 AM
Thnx!
.Thag
Windows 10, Archicad 28
1 REPLY 1
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2013-12-15 12:32 PM
2013-12-15
12:32 PM
They are combining together because you have the each beam set to the same material or same cut fills. You'll have to change each beam to a different material or cut fill than it's neighbor. This may mean that you'll need to duplicate materials in the Material manager or the Fill manager so you will have enough to go around.
There is something similar in the Complex Profile Manager when you make a complex profile. Make sure separate pieces are different fills so they don't merge when the profile is extruded.
There is something similar in the Complex Profile Manager when you make a complex profile. Make sure separate pieces are different fills so they don't merge when the profile is extruded.