Is it possible to create Slanted Curved wall??

[Anonymous]

So... 🙂

[Anonymous]

Dwight wrote:
NOT AT ALL!

I made curved, non-vertical walls in AC 10 by magic-wanding arcs or splines using a very small magic wand segment length. This, with a custom profile and - uh, was it the wall tool or the beam tool????

Attached is a composition using the technique with some SEO fun - wall segment stands alone as an example.

No, I need perfect curved wall but this is nice wall too

Rod wrote:
Only solution!

Like Dwight did, it's possible to merge simple walls into almost curved 🙂 That's why I said it's "maybe the best solution"

[Anonymous]

Dwight wrote:
NOT AT ALL!

I made curved, non-vertical walls in AC 10 by magic-wanding arcs or splines using a very small magic wand segment length. This, with a custom profile and - uh, was it the wall tool or the beam tool????

Attached is a composition using the technique with some SEO fun - wall segment stands alone as an example.

One simple problem with your solution is with openings. and this object needs huge CPU-power.

[Djordje]

Dwight,

Could you reduce the images a bit? Please?

[Dwight]

Sure. But not much more than they do in Archicad 11.

Curves is curves.