Joint Lines/Reveals

[Anonymous]

I constructed a truss using linework and subtracted it from the exterior wall of my building to create joint lines. The joints show up in AC, but not plotmaker. Has anyone ran into this problem?

[James Murray]

Sounds like pen settings. Make sure the pen of the subtraction isn't white in PM. It can't be layers, assuming the wall itself is visible.

[Anonymous]

It is not a pen issue, I tried that. It is wierd that it they show up in AC, but not in PM. The reveals even generate a shadow in AC and not in PM. They also show up in section when they are being cut through, but still not in elevation.

[Djordje]

Kevin wrote:
I constructed a truss using linework and subtracted it from the exterior wall of my building to create joint lines. The joints show up in AC, but not plotmaker. Has anyone ran into this problem?

Any chance on getting a screen shot?

Are the layers in the placed view OK?

[Djordje]

Kevin,

Please do not duplicate the topics. If you asked the question once, don't ask it again. Creates confusion.