Shell tool and Textures
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-10-04 05:19 PM - last edited on ‎2023-05-24 07:03 PM by Rubia Torres
‎2011-10-04
05:19 PM
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2011-12-14 01:56 PM
‎2011-12-14
01:56 PM
I've got the same problem with a simple roof containing a curve.
At the bottom of the roof where the slope is almost vertical and up to about 45 degrees on the curved section the textures and hatch are consistent and correct. After this point the texture and hatch turns 90 degrees!
Am I doing something wrong or is this a known problem with textures on shells?
Is there a fix or work around?
At the bottom of the roof where the slope is almost vertical and up to about 45 degrees on the curved section the textures and hatch are consistent and correct. After this point the texture and hatch turns 90 degrees!
Am I doing something wrong or is this a known problem with textures on shells?
Is there a fix or work around?
Apple iMac Intel i9 / macOS Sonoma / AC27UKI (most recent builds.. if they work)
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2017-08-21 07:16 PM
‎2017-08-21
07:16 PM
Has anyone found a work around to this?
Need to create a fluid rainscreen over a main wall which the curtain wall does brilliantly but the hatcing makes it almost non viable.
Need to create a fluid rainscreen over a main wall which the curtain wall does brilliantly but the hatcing makes it almost non viable.