chain wall doesn't work after update

[mobilman]

my chain wall icon and curved wall icons do not open after update from 27 to 28 any help to fix this

[Lingwisyer]

Check if your toolbars are setup properly? You could test with the default work environment.

[mobilman]

itried that, its set up as default settings, also tried looking at layers to make sure they were set up correctly. 

[Barry Kelly · Accepted solution]

If you mean the pop-out does not show, try holding for a fraction of a second when you click the button.

A quick click will not work.

Barry.

[Lingwisyer]

Can you press G to cycle through the options?

[mobilman]

yes this works thank you, didn't know I had to hold the button, 27 just clicked

[Barry Kelly]

It has always been like this as far as I know - I just checked 22 and it is the same there.

Just checked 27 as well and it is the same for me there too.

Maybe it is a few milli-seconds slower in 28 that is making the difference.

It is what a call a 'long or slow' click rather than rather than a 'short or quick' click.

The speed must have changed because others have been caught out as well.

Barry.