Aligning Textures

[#1]

Nik,

set origin for texture for each wall to same base point, in 8.5 open 3D window select walls >Edit > Align 3D texture > Set Origin - click base point on corner.

regards,
Scott Boyd Turner

[#2]

Nik,

set origin for texture for each wall to same base point, in 8.5 open 3D window select walls >Edit > Align 3D texture > Set Origin - click base point on corner.

regards,
Scott Boyd Turner

[Dwight]

forget?

[Anonymous]

Hey guys.. The above solution didn't help me here.. I am stumped!

Thanks

[Anonymous]

Eliminate eave?

[Aussie John]

im guessing the eave is a separate library part. Unfortunately set the origin doesnt apply to objects. The 3D script needs is the coor and vert commands - Good luck as the manual is fairly unhelpful in this.

The simpler option is to extend the roof and SEO the roof part of the eave

[Dwight · Accepted solution]

The ATKIQuikFix™ for this is to create another material with texture mapped at 90 degrees to the original. It still won't be originated correctly [unless by coincidence] but it will run the right way at least.

[Dwight]

Or make an eave element that doesn't include the roof portion, letting that be continuous with the actual roof....

[Anonymous]

Thanks Guys for the help... Well, I tried all options with the part.. No luck.. The new material idea would drive me nuts being slightly off even if only I knew (and Dwight.. ) So I just extended the roof overhang.. thankfully it stays "in front" of the Eave part..

The Author must have tested this? I tell you slowly I am realising it is best to do all possible with native AC tools and Libraries..

Thanks Again!

[Anonymous]

May I ask another.. what is this line with the little tick mark on all my roof planes?