Informationen zu RafaelPretti

RafaelPretti · 2025-04-02

Hi all,I'm trying to model a timber paling fence using the railing tool and despite multiple attempts I'm not able to match the baluster and the segment patterns.The balusters are made of 20X150 mm "palings" with a 10mm spacing between them.The inner posts as set to max leng...

RafaelPretti · 2025-04-06

I'm adding additional nodes, its the same railing "object".I did think about just adding an additional railing for every turn and just keep them as straight lines but if I have a smaller length (see my reply to Barry above) then the gaps seem to appear once again.

RafaelPretti · 2025-04-06

Hi Barry, I had tried this approach as well with equal distribution on both segment and baluster settings.Although it seem to be the best one so far it still has some issue whenever the length is smaller then the "max. lenght".:Please see below 2 screenshots, on of them you'...

RafaelPretti · 2025-04-03

HI @Lingwisyer thank you for the tip, I tried that approach as well, the issue is I need the model to be accurate for scheduling purposes (no. of inner posts, no. baluster, etc) for proper quoting.

RafaelPretti · 2025-04-03

HI @runxel I tried the same approach as you did and although it works well when the distance between inner posts are at the maximum, as soon as the distance is smaller or there is a "corner" there are gaps on the model.Any idea how to fix this? I tried so many different ways...

Benutzerstatistik

Benutzeraktivitäten

Railing tool Pattern Setting doesn't match with Baluster Setting

Re: Railing tool Pattern Setting doesn't match with Baluster Setting

Re: Railing tool Pattern Setting doesn't match with Baluster Setting

Re: Railing tool Pattern Setting doesn't match with Baluster Setting

Betreff: Railing tool Pattern Setting doesn't match with Baluster Setting