Hi, I save a solo project into an project archive and the file jumps
from 142 MB to 1.7 GB. That is 13x. Why is this? What is taking up so
much space when saved as pla? Didn't happened before. PS: It saved from
AC26 to AC26. Thanks
Hello, Usually i work on the plan that is not always with the north up,
it can be sideways or down.I wonder how is it possible to link or set
the already created 3D views that will show the correct shadows for
example the north is facing down this ti...
Hi, I want to know if it is possible to set for example the default
elevation layer combination to be "Plans Detailed" or any other it
doesn't matter.I know i can create a view and save it, but i need this
because if am in a saved view, then go to fl...
Hello, I know that it is possible to set a different surface for wall
opening by setting also the wall edge but it is not enough. I wonder if
it possible to show correctly a different surface, in the interior
(behind the window - red line) would be t...
I unchecked everything except compress file, the filesize still around
the same 1.7 GB (it reduced by 150 MB ). What else can i do? PS: This
didn't happen in earlier versions, usually it just doubled.
Continuing to round up i get to the beams which had a premade property
called segment round with the expression below. I need it to round up
the nearest .5 for example 842 should show 845 cm, 844 should show 845
cm. How can i change this formula caus...