Hi, I created eave for a side edge of sloping roofs as showed in 1st
picture, the problem showed in red circle, so I made a section to change
angle of eave up to 15° as same as roof pitch as showed in 2nd picture.
Then the eave and roof edge was alig...
Hi I was creating a roof using multiplan complex roof method, one
problem is in the red area showed in picture 1 and 2, the room wall is 2
feet lower than the other rooms, so I want to drop down this area root 2
feet, but I couldn't find the way if I...
Hi guys, I'm learning to draw roof, now I encounter difficult case as
showed in the below pictures. That's an unregular shape as marked in red
color, after a lot of trying I have not find the way how to create roof.
So I'm asking help here, thanks a ...
It's interesting, I think I should re-learn some geometry again then I
try again based on your solution. Anyway, so kind and help of you, I
have one more problem abou roofs just written in a new post, could you
please have a look, thank you very much
Hi Barry, your suggestions are always helpful for me. I tried a lot if I
want to keep 2 roofs' ridge in the same height, hips could't exactly
align to one line, whatever I slighted modify roof thickness or pitch.
So finally I tried to use same pitch ...
Hi Karl, Thanks for your help, I tried to use this method to create
sloping roof, but one problem I couldn't solve. As showed in below
picture, I drawed 2 roofs, No.1 is in 26° and No.2 in 15° , by this
option the roof ridge attached to 2 walls can b...