About Daniella1985

Daniella1985 · 2026-06-28

I want to make a 45-degree bevel at this opening. Which command should I use? I have been experimenting for several days, but I can't make it the same on all four sides. Is my direction wrong? ! 洞口切割 IF hole_r_on_1 OR hole_r_on_2 OR hole_r_on_3 OR hole_r_on_4 OR hole_r_on_5 ...

Daniella1985 · 2026-06-13

I can only do the top side, I can't handle the other three sides. Can I just input the cutting angle? The black one is a cube. I also want to cut it, how do I use it? I don't know how to use those commands 3D ! 磁磚群組 IF chamfer_t > 0 THEN ADDZ B + 0.001 CUTPLANE{2} -45 DEL 1 ...

Daniella1985 · 2026-05-08

 Operating system used: Windows

Daniella1985 · 2026-06-16

I have a new project: how to cut a 3D floor at a 45-degree angle, like a floor tool. I'm having trouble; I've failed many times with the syntax. group "tiles" MATERIAL sur_mat x_phase = tile_offset_x - INT(tile_offset_x / (tw + gv)) * (tw + gv) y_phase = tile_offset_y - INT(...

Daniella1985 · 2026-06-06

I'm very sorry it took me almost four weeks to reply. The 2D and 3D code you provided was very helpful and gave me a lot of direction; it was invaluable because I couldn't achieve the compensation effect when cutting blocks and tiles. Thank you so much!You understand what I'...

Daniella1985 · 2026-05-08

3D-PRISM_ How to define tiles and holes? To avoid excessive clipping? I am a GDL beginner. GDL treats the entire outer frame as a hole, causing the whole piece to disappear

User Statistics

User activity

How can I add 45-degree chamfer hotspots on all four sides of this opening without recessing? Is the

How to bevel around the edges of tiles

These are floor tiles. I want to cut the holes correctly. Which command should I use? It seems like

Re: How to bevel around the edges of tiles

Re: These are floor tiles. I want to cut the holes correctly. Which command should I use? It seems l

Re: These are floor tiles. I want to cut the holes correctly. Which command should I use? It seems l