I have been working on a project which for various and sundry reasons
had to be broken into two files and then had to be published in two
parts which did not correspond to how the files were separated. Layouts
were composed in both files and then req...
I have a 2" frame with 1/4" shim space all around. I can not figure out
how to have the frame show as well as the rough opening in Storefront
Window 19 in elevations and sections. The black dots indicate that the
information is there but not visible....
Anytime I open Archicad from the finder, I get the Dialog box shown
below. The setting in the Firewall pane is set to accept incoming
network. Anyone else getting this. Does not appear to do any harm, but
it is annoying.
I created a complex profile for the raked gable end of a roof and
assigned a roof shingle texture to one of the components that make the
profile. I placed a beam using the complex profile and all is well
except I am unable to align the 3D texture. If...
I have been working on a project in which I have already created a
number of sheet layouts, and something in the file has developed a
problem, that while not fatal is annoying. (In the Navigator Preview
window, when in 3D mode, the overhead view of t...
There was a long discussion concerning this some time back. May be
I'm the one that complained about this awhile back and your post just
made me realize that I am not seeing the popup. Both in 18 or 19. The
only thing that has changed is that I am running off of a Temporary
License because the new Archicad Software ...