cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Light works rendering engine phase 1 less than a minute

Anonymous
Not applicable
Hi i am using Archicad 10 _ each time i do a 3d phot graphic render i et as far as Light works rendering engine phase 1 less than a minute and pit goes no further

Has anybody any had experience of this ?

If so could you Help me out with some advice ??

Thanks Myles.
4 REPLIES 4

Dwight
Newcomer
Is this a new problem?
With this file only?
How complex is the file?
Do you get any error messages in the 3D Report?

Put your machine configuration in your forum signature - especially how much RAM.
Dwight Atkinson

Anonymous
Not applicable
Hi

it is not new problem,

i am running a 2.5GB DDRSDRAM if that will help you.

The model is pretty complex - and pretty big too.

Any advice would be a help - Thanks Myles.

Dwight
Newcomer
And the 3D Report??? - you may need to locate this and enable it.

I think this is a corrupt element - cut the project into segments through marquee or layer visibility to possibly isolate it.
Dwight Atkinson

Anonymous
Not applicable
Dwight wrote:
And the 3D Report??? - you may need to locate this and enable it.

I think this is a corrupt element - cut the project into segments through marquee or layer visibility to possibly isolate it.
Try to remove the shadow from the 3d setings, if it has the shadow on, it will take more time to process it!

Start a new conversation!

Labels

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!