Jogging A Section Cut

[Anonymous]

I was hoping one of you might know how to jog a section cut. I know that I can jog a section cut @ a 90 degree angle, but I cannot find out how to change that angle. Basically I want jog the section along the dashed blue line on the attached PDF, is this possible, or should I just give up now?

[Anonymous]

You can only look at a section in one direction. You can have a breaked section.

But maybe it is a work around to create 2 sections and place them adjacent on a layout?

[Anonymous]

I had the same task.
My way was create two section on the same ID later will joint it in layout.
or you can use the Interior Elevation tool

[gpowless]

Why not do a 3d cut and turn the viewpoint on to a side view?