Mixture of decimal and and fractional dimensions

[Eric Milberger]

My model will not stay feet and fraction.  It keeps changing to decimal and is not consistent from dimensioning a elevation.

the saved format does not stay.  Even though I tell it no fractions it still creates decimals.

Operating system used: Windows 5003

[Ricardo Lopez]

Hi @Eric Milberger 

Check whether the Dimensions in the View Settings are correctly applied in all views and whether they have been saved.

Regards.

[Eric Milberger]

They are replied properly and change on their own.  the changes are not sticking

[Eric Milberger]

The work then change back almost immediately.  the changes do not stick If I use the terminology correctly - there is only one Screen bur plans and sections and elevations.

right now I am modeling and dimensioning the plan and the dimensions either change almost immediately back to decimal or do when I save and exit and reopen.

I do not know where to go from here as I tried to reach tech and nothing but an email on what it cost for support.  I think this is more a misbehaving software than a help for how to place a dimension.

[Eric Milberger]

I have already adjusted the setting and they will stay for a minute or few and will revert back - as if they are stuck in metric with imperial as a mix.  I have already done as you suggested probably 50 times.

[Barry Kelly]

Can you show a screen image of your dimension style settings, showing the settings for the fractional dimensions.

Like this for example...

Then also a screens image of the view settings so we can see if the correct dimension style is applied.

Also a screen shot of you wrong dimensions when the correct dimension style is applied.

Barry.