Section ID wrong
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2004-07-13
01:16 AM
- last edited on
‎2023-05-30
12:29 PM
by
Rubia Torres
‎2004-07-13
01:16 AM
In our office, we identify sections by letter ("A," "B," "C," etc). However, when I ID the sections in ArchiCad by letter, PlotMaker lists them as "1," "2," "3," etc. The numbers and letters align as would be expected... usually. But how can I get PlotMaker to read the ID properly, and print letters in the section marker rather than numbers?
2 REPLIES 2
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2004-07-13 01:57 AM
‎2004-07-13
01:57 AM
In PlotMaker:
Select the layout (in Navigator) that the section drawings are on.
Open the layout settings (the button at the bottom of the Navigator palette).
Select the drawing numbering style.
Select the layout (in Navigator) that the section drawings are on.
Open the layout settings (the button at the bottom of the Navigator palette).
Select the drawing numbering style.
Anonymous
Not applicable
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2004-07-13 02:44 AM
‎2004-07-13
02:44 AM
Knew it had to be something simple I was neglecting. Thanks!