Dorr Markers rotated 90 degrees

[Dave Brach]

When I place an associative lable for my doors, the number is rotated 90 degrees, and I can't figure out how to correct this. Can anybody help me?

[David Maudlin]

Dave:

I was able to reproduce this bug by mirroring a wall with a labeled door, using the Label Door-Marker 15. There is code in the label for Wall_Direction that I think is supposed to correct for this. The only solution I found was to change the Label Rotation value (Label Settings > Symbol Label > Rotation Angle) to 90.01˚ (setting this to 90˚ does not work correctly).

It would help if you named the Label you are using, as well as added screen shots of the problem.

You should add a Signature to your Profile (click the Profile button near the top of this page) with your ArchiCAD version and operating system (see mine for an example) for more accurate help in this forum.

David

[Dave Brach]

Thanks, David.

I am using Label Door-Marker14. In my case, if I change the rotation to 270.01 degrees then it is correct. So that works but it's a little annoying.

Attached is a screen shot

[David Maudlin]

Dave:

I found this problem in plan, doors in walls running x axis are ok, doors in walls running y axis show the bug. Besides trying to correct the GDL code in the Label, I don't see a solution.

David

[Dave Brach]

I found that if I use the eye dropper/needle to transfer properties from a window label to the door label, then it corrects the door label.