error in 2D view?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 03:25 PM
I used autcad before.
And i met an error in 2D view.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 03:31 PM
ynwsbox2008 wrote:
hi , i am new to archicad.
I used autcad before.
And i met an error in 2D view.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 03:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 03:42 PM

i did some GDL during Spring Festival .
And i made cabinet and steel.
Cabinet is to be put on the top of the Steel.
But in 2D view, steel should be draw by Broken line, not Real line.
Some mistakes happened during GDL?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 03:55 PM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-23 05:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-24 02:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-24 02:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-24 02:35 AM
here is CB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎2007-02-24 02:49 AM
show me something about this, thank you:)
I think i can , and i must , autocad can not run by MAC.
If i can , my imac 20 will be useful:)