Curved and sloping window transom

[Anonymous]

Good morning

I am trying to model a curved section of curtain walling, the top transom also needs to follow the line of a sloping soffit. Im new to ArchiCAD, I can form my transom using a complex profile and the wall command. But can not find a way to slope/ angle it so that in elevation one end is lower than the other.

Any thoughts?????

[Djordje]

Cut it off by a conveniently placed roof plane.

Use Solid Element Operations to cut off what you don't need.

[Thomas Holm]

Phil79 wrote:
I can form my transom using a complex profile and the wall command. But can not find a way to slope/ angle it so that in elevation one end is lower than the other.

Use the complex profile with the Beam tool instead. It will slope.

[Anonymous]

The sloping beam tool will work with a straight profile, but i need to curve it in plan. all i have managed to do is draw what looks correct in plan but in elevation it is a series of beams all at the same angle. Not a continuos slope as needed.

Also any ideas on how to trim a beam to a non perpendicular column?

[Thomas Holm]

Please add version and platform in your signature.

[Anonymous]

I am on 11 using a MAC.

Regards

[Thomas Holm]

You're right. I hadn't tested this. The beam tool doesn't bend. If you place beams along a curve with the magic wand/space bar, it segments. And instead of continuing upwards, each segment starts at the same level.

I you manually raise the level of a segment to match the previous, they will join in 3D and section, but it will look a bit weird and the joint will be visible. See attachment.

I guess itäs doable this way, but Djordje's tip of cutting a curved wall with SEO or trim to roof is pobably better. There is a caveat to that one too. The cut will be a plane, not the spiral ramp that you really need. Perhaps you could use the spiral ramp object in the library?

Otherwise, your best bet for this is the add-on Objective! Try it!

[Anonymous]

Thanks for the help gentlemen