2022-10-13 04:28 AM
I want to fill the mesh with fill like in cad in elevation.
What should I do?
how i know
1. Turn off the mesh and redraw the Fill.
Solved! Go to Solution.
2022-10-13 06:58 AM - edited 2022-10-13 06:58 AM
Sorry for some reason I was thinking of a section not an elevation.
In elevation it is the surface that has to have a fill associated to it as Kevin mentioned.
And you must turn on the 'Surface Cover Fill Foreground' in the elevation settings as you have shown.
Barry.
2022-10-13 04:45 AM
The mesh needs to be solid (which it looks like yours is) and then use a building material that has the cut fill type that you want to see.
Barry.
2022-10-13 05:31 AM
Can you show me the material?
I can see it from the section, but not from the elevation.
2022-10-13 05:47 AM
If you want the earth fills from the "Elevation" you need to control it via cover fill (like how you would normally show brick pattern from elevation)
1. Check your section/elevation to show "Surface cover fill Foreground" on
2. Choose the mesh edge with earth cover fill (check your surface)
2022-10-13 05:57 AM
thank you
do you mean this?
Are there any other settings?
2022-10-13 06:58 AM - edited 2022-10-13 06:58 AM
Sorry for some reason I was thinking of a section not an elevation.
In elevation it is the surface that has to have a fill associated to it as Kevin mentioned.
And you must turn on the 'Surface Cover Fill Foreground' in the elevation settings as you have shown.
Barry.
2022-10-13 10:26 AM
Thank you so much