Low 42" high wall not showing as overhead in ceiling plan

[Llian]

Can someone guide me through this....why the low 42" high wall [highlighted in green] is still showing as solid line instead of dashed line?

[Richard Morrison]

Based on the height of your cut plane, it's probably NOT overhead, so you won't get a dashed line. Also, if this is supposed to be an RCP, then it probably shouldn't show up at all.

[DGSketcher]

As Richard has indicated, cut planes are likely to be your issue assuming the wall is at the right elevation for what you want to show. As a crude guide...

A wall completely below the cut plane will show in outline only
A wall intersecting the cut plane will have fills
A wall above but falling within the cut plane range will be shown as overhead

I have found cut planes to be quite entertaining as you chase around adjusting their range settings and altering element display settings to make sure they show what you want.