Module madness!

[Tom Krowka]

I have a building, three stories, that I inserting as module on a big site .pln. There are pieces of trimmed walls that stick out through the roof that do not show up in the .pln drawing. XX!!#$@##$%$@!!!

Layer settings are the same, etc.

Any suggestions there?

[Anonymous]

give this a shot.....check off the adjust module angle

[Anonymous]

Tom wrote:
I have a building, three stories, that I inserting as module on a big site .pln. There are pieces of trimmed walls that stick out through the roof that do not show up in the .pln drawing. XX!!#$@##$%$@!!!

Layer settings are the same, etc.

Any suggestions there?

Tom,
Sounds like you've used SEO's to trim the walls to roofs...SEO's don't work with multistory modules when the roofs and the target walls are on different stories.

HTH,
Dan K

[Tom Krowka]

Dan:

Tom,
Sounds like you've used SEO's to trim the walls to roofs...SEO's don't work with multistory modules when the roofs and the target walls are on different stories.

This question is not directed to you.......

WHY THE ##@!$$#@%&^% NOT

[TomWaltz]

How nice life would be if modules could use SEOs and have their own Element ID's....