Parametric design
About Rhino & Grasshopper and PARAM-O.

Param-o formulas

Gyula Toth
Participant

Good afternoon Everyone!

 

I am recently using param-o and at the moment I am creating an object, where I have two other object linked together. One of them should be moved along the other to a pre-defined positioned. To calculate the exact position, I need to round up one of the formula results inside the add-on. Is it possible to mark/ add roundings inside Param-o?

 

Thanks in advance,

Best regards,

Gyula Tóth

2 ACCEPTED SOLUTIONS
2 REPLIES 2
Solution
cuba
Advocate

Use Floor to round down (1,5 will be  1) and Ceiling to round up (1,5  will be 2)

 

Floor_Ceiling.png

Apple M1 Max 32 GB Ventura
AC27
Solution
Gyula Toth
Participant

Ceiling did the job. Now it works as it is supposed to do so.

 

Thanks a lot. 🙂

Didn't find the answer?

Check other topics in this Forum

Back to Forum

Read the latest accepted solutions!

Accepted Solutions

Start a new conversation!