my new composites didn't show the lines that i've created from the cover fills

[scrptdfalls]

hi so I've created new fills, surfaces, building materials & composites for walls (I made it to fulfill the standard in Indonesia) but when I tried to create the new walls that I've created, the line symbol didn't show up. what should I do to fix it?

[Lingwisyer]

Please provide screenshots of your fill settings. It would also help if you include some information about your system setup. Refer to the links in my signature about creating a post and adding a signature.

Ling.

[Patrick M]

this could be a huge range of reasons your elements are not shown as their settings say they should.

-graphic overrides

-renovation filter

-on screen view options > show vectorial vills

-in section/elevation, the cut and/or uncut lines, fills, pens can be overwritten in the viewpoint/marker settings

-trace reference could be on and set to show fills transparent

-pen set could be using white pens for fills or skin separator lines for the pen set applied to the view

-walls could be set to "outlines only" or otherwise cut settings do not qualify it as a cut element for given floor plan cut plane settings

-fills have not been tracked through to correct bMats and Surfaces as their relevant sub attributes

-default pens for surfaces or bMats are a white pen

As @Lingwisyer said, screen shots of the element settings and what they look like would be a good place to start sleuthing this out

[RobbLittle]

Thanks, I will check and if I still face any issue, I will share the screenshot.