About Chris Pooley

Chris Pooley

Hi, I am trying to figure out what I need to adjust to change the Wallhole Height for the Double Door 25 tool? The door leaf's will be 820mm x 2040mm - I want the wallhole height to be 2100mm. I thought I would adjust the frame and leaf, but when I c...

Chris Pooley

Hi, I am trying to make the railing show like the stairs, as in, display differently above the break mark, I want lighter lines and no fill (as per the stairs in my picture). In the rail selection settings I have set the "Relevant_Bottom Story" to "b...

Chris Pooley · 2024-02-29

Hi all, I am having troubles working out what I am doing wrong with my settings? In the attached images, the wall is sitting at just over 600mm from its associated FFL, so I thought if I set the cut plane at 800mm I would see it cut through? The wall...

Chris Pooley · 2023-11-15

Hi All, I am trying to make the detail marker show the layout the view is placed on. I can manually draw write the layout ID in there, but if I add more sheets or change the order of the sheets, I would like this to automatically update. I know this ...

Chris Pooley · 2023-10-30

Hi All, I have had 2 jobs now where I have needed to "snip" a 3D perspective using the windows snipping tool and pasting onto the layout, rather than using a 3D perspective. My preferred method would be to use a perspective, but something in my model...

Chris Pooley

Wonderful, thank you for that Barry.

Chris Pooley

Hi Anna Mindi, What are your settings for the surface for that element? Can you send a picture of that? - Like what I have attached Also, can you send an image of the elevation settings you have, under the model appearance tab? - Like what I have att...

Chris Pooley · 2024-03-27

Hi Juan, Thanks for the reply. I did not try that, I will try that on my next job. Using the "Tree Model Simple 25" trees was a good solution as Lazlo suggested. Thanks again

Chris Pooley · 2024-03-01

Thank you for that, it was that I had the floor to ceiling height set to 300mm, as there is no floor above it. Thanks again.

Chris Pooley · 2023-11-15

Thank you very much.

User Statistics

User activity

Adjust Door Sizes

Railing view above current story

Floor Plan Cut Plane Settings

Detail Marker to show layout ID it is placed on

3D Perspective generates far too large PDF

Re: Adjust Door Sizes

Re: New texture in elevations

Re: 3D Perspective generates far too large PDF

Re: Floor Plan Cut Plane Settings

Re: Detail Marker to show layout ID it is placed on