Informationen zu alexliz

alexliz

When I select Panic Bar for handle, it is placed on what I perceive to be the outside of the room. I thought I have understood the object the wrong way around, but when I add the outside Kick Board, I see that it actually places it on the inside, i.e...

alexliz · 2025-11-06

When I select a Stair and go into Edit, then select one tread and wait for the pop-up to show the 3 buttons (select all down/all/all up) I click on one of them but nothing happens. Is this a bug or have I gone crazy?

alexliz · 2025-10-30

I go into one of the zones I have already placed, into Zone Selection Settings > Settings > Zone Identification In there, I have checked the boxes for: Apartment ID Position House Number and have entered data in the relevant fields at right. I am loo...

alexliz · 2025-09-23

Is there a way to force the wall to display correctly and not allow the door frame pen to 'cover' over the wall's outline pen, effectively making it look like there's a gap in the wall (or some other modelling issue)? I have resorted to manually draw...

alexliz · 2025-09-05

I am developing various options for this client. It's a small conversion of an existing building. Some elements must be visible only with option 1 or 2 on one design aspect. But... ..on another design aspect, they must be visible only with option A o...

alexliz

Thanks - I already had the US library installed. I can confirm that the 'D1 Entrance 27' works properly.

alexliz · 2025-11-08

Thanks for the suggestions, Laszlo. Vectorial Engine and turning off 3D Antialiasing didn't make any difference. I am not sure I can try with a different graphics card driver on my MacBook Pro.

alexliz · 2025-11-07

Hi Barry, yes, curtain wall frames/mullions can be selected with the tool. I now note that, with stairs, I can't even select a single tread/riser in 3D. In plan view, I can select them, but only manually (holding SHIFT), not by the 3-button pop-up.

alexliz · 2025-11-07

Thanks. It used to work fine (although it has been a while since I last needed it, so not sure when it broke). It happens with any project, any stair. Even if do a 'New & Reset All'. I was on Archicad 28.3.0 (6003) INT on my MacBook Pro running Sonom...

alexliz · 2025-09-23

Thanks Lee. In the example I show above, it affects both ends of the door, not just the one where it's at the wall corner. It does need to be addressed.

Benutzerstatistik

Benutzeraktivitäten

Door 27 opening wrong way (?)

Select multiple treads / risers not working

How can I list Zones by any of their parameters in Schedules?

Doors interfering with wall outline appearance

Can Elements be linked to combination of Design Options?

Re: Door 27 opening wrong way (?)

Re: Select multiple treads / risers not working

Re: Select multiple treads / risers not working

Re: Select multiple treads / risers not working

Re: Doors interfering with wall outline appearance