Hey all, So i am trying to automate some object IDs, something that
should be simple but is turning out not to be. I have built a favourites
library with various objects such as lights etc (just symbolic
representations), in the favourites i have giv...
Hey all, Having a weird issue when trying to create a worksheet. I am
trying to create a worksheet for a portion of a ground floor plan. I can
make the worksheet and i can open it in the Project map, and its all
fine, i can edit it, change pen sets, ...
Hey all, A problem I'm not sure how to fix! This could relate to a wall
or roof but for this i will use a wall as an example. I am trying to
create a timber frame wall with the following build up. Raised seem
zinc. 12mm Plywood. 19x50mm Cross Battens...
Hey all, I am trying to import an object in to a project. Link below. I
can load the GSM file but it then asks me to load the Macro which i
assume is the INT file - can anyone advise as to how you do this?
Hey all, Im new to archicad so i hope there is a simple solution to my
problem. I am drawing a project at an early stage and in the section
where elements meet - a floor and a wall, a ceiling and a wall etc -
there is a line showing between the 2 ele...
Hey, Yes. So i was dragging the worksheet straight from the project map
to the layout, rather than creating it in the project map, bringing it
into the view map and then dragging on to the layout from there. Which
apparently can mess up the reno filt...
Hey Barry, No not working. When i do that and then go to the layout
sheet the sheet updates but with the wrong reno filter, or if it do what
you say and then right click and 'redefine with current window settings'
it jumps back to the wrong reno filt...
Barry, Thanks for getting back to me. I had tried pretty well what you
described, the only difference is i was hitting 'rebuild from source'
rather than model. So i have tried it with 'rebuild from model' but it
does not show up when i right click an...