cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Design forum

Trim function issue

SectionSeven
Participant

Wondering if anyone can advise. When using the trim tool between the roof plane and wall, I end up with the wall showing on the surface plane of the outer roof. Attached image shows the issue. Why would this occur?

Screen Shot 2022-09-25 at 8.23.04 AM.png

2 REPLIES 2

Lee Hankins
Advisor

This happens because the building material of the wall is a higher priority than that of the roof. You need to either change the material of the roof to one that has a higher priority than the wall or open the Building Material settings from the Attribute Manager and increase the priority so that it is higher than the material used for the wall. 

Lee Hankins
ArchiCAD 4.5 - ARCHICAD 26UKI Intel 4019 and Apple Silicon
macOS Ventura (13.0.1)

Thanks for that. Appreciated.

Still looking?

Browse more topics

Back to forum

See latest solutions

Accepted solutions

Start a new discussion!