- last edited on by
Molinda Prey
Hi everybody. I had a trouble with the Stair Tool's Break Mark. I have two stairs on one floor plan and the orientations of the break marks are different:
They're not mirrored or copied. The only difference between those two is only the width. One has the width of 1400mm while the other is 1500mm. I need the break marks to have one and the same orientation.
Operating system used: Windows 11
1 ACCEPTED SOLUTION
Accepted Solutions
- last edited on by
Laszlo Nagy
Tazo:
Under Stair Settings > Floor Plan Display > Break Mark > Break Mark Distance and Angle > Angle to Horizontal: try a negative value.
You should add a Signature to your Profile (click the Profile button near the top of this page) with your ArchiCAD version and operating system (see mine for an example) for more accurate help in this forum.
David
- last edited on by
Laszlo Nagy
Tazo:
Under Stair Settings > Floor Plan Display > Break Mark > Break Mark Distance and Angle > Angle to Horizontal: try a negative value.
You should add a Signature to your Profile (click the Profile button near the top of this page) with your ArchiCAD version and operating system (see mine for an example) for more accurate help in this forum.
David
Still looking?
