Good morning! I am having trouble with the bottom rail of my railing. I
have two inner posts and the rail is continuing through the posts. I
would like the rail to be restricted to the section with the panel in it
- so not between the two posts. I am...
Hi everyone, I can't get posts to show in 3d despite them being there in
the settings. I wonder if it has anything to do with the node settings -
which are greyed out so I can't adjust? I would appreciate any input on
this as I have spent a number of...
Hi, Some of my surfaces have turned off and are showing as white. (See
image) I was working in 2D and went to 3D and discovered my model had
changed. I wasn't working on the things that have been affected and have
checked the settings of everything a...
Hi all, I would like to resize an imported drawing along the x axis only
but cannot because the x and y axes are locked so they stay in
proportion to each other. Can they be unlocked? I am working in SE18
Hi, Is it possible to slope a roof (or any other tool) across two
directions - so front to back but also side to side? I can only get a
single plane roof to slope in one direction. I'm using SE18. Thanks
Lingwiser: It is happening in new railings as well. I have been to Work
Environment and checked the tool box and tool settings and everything is
on/visible. David: I have to send off soon so will add posts seperately
and make do. Hopefully it's just ...