About Heftor

Heftor

Hi Community, I'm looking for the best way to handle a window replacement in our project. We have an existing opening with an old window. We need to: Demolish the old window. Install a new window in the same existing opening, with a different reveal ...

Heftor

Hello All, I have a question regarding the "Reserve" functionality for project objects. In my daily workflow, I reserve the objects I need to work on. However, sometimes, I might forget to release one or two items when I'm done. This can unfortunatel...

Heftor

Hi, I'm having trouble getting the automatic area reduction for low ceilings to work and would appreciate some guidance. This is my ceiling: Here is what I have done: In Project Preferences > Calculation Units & Rules, I went to the Zone Area Calcula...

Heftor · 2025-09-30

Hi, I’ve meticulously set up my composite wall structure, but when I place an opening, it cuts through every layer, including the crucial outside finish (brick, siding, stucco, etc.). This creates an incorrect representation in both 2D and 3D.is ther...

Heftor · 2025-09-29

Hi everyone,I'm getting an unwanted separation line in my composite wall, the wall has different thickness in different places so i cannot find a way to keep the reference line align. The line appears exactly where the wall thickness changes, Is ther...

Heftor

Thank you for your reply, @Erwin Edel.You understood the question correctly, and the two-window solution you described is technically what we tried. However, it creates the visual result you see in the attached images: the entire element, including t...

Heftor

Thanks @Stefan L_ , Normally is me the slowpoke, i forgot to close the program last Friday and I have a few things reserved  and I sent the changes but I did not close, so I was wondering if there is a work around to solution this.I foresee this wil...

Heftor

Hi @Laszlo Nagy , Thanks for the insight, I will be aware of that next time that i start modelling. I see that works also for columns, that I used to make the over structure. Thanks for the support, Hector

Heftor

Hello all, I have to isolate the room to find that there is an error. Unfortunately, I cannot find which is the "line" that´s messing with the room calculation. So far, this is what I have done: Subtract the ceiling from the room: Recalculate the roo...

Heftor

Hi @Barry Kelly and @Olivier-IDAO , OK, I have done what you advised: Trimmed to the roof: before update: After update: but the definitions from the zone doesn´t match: still there is no reduction in the lower part and the crop is almost 1m more ...

User Statistics

User activity

How to set status for window replacement (Existing Opening, Demolish Old, New Window)

Can an admin release another user's reserved objects?

Zone Area Reduction for Low Ceilings Not Applying

How to Make an Opening in a Composite Wall Without Removing the Skins

Wall separation line when reference line is not align

Re: How to set status for window replacement (Existing Opening, Demolish Old, New Window)

Betreff: Can an admin release another user's reserved objects?

Re: Zone Area Reduction for Low Ceilings Not Applying

Re: Zone Area Reduction for Low Ceilings Not Applying

Re: Zone Area Reduction for Low Ceilings Not Applying