With the introduction of design options in v27, are there any known
settings to adjust in the IFC Translators? We communicate with a MEP
consultant that uses Revit. Their Revit crashes up opening our IFC's
that originate in Archicad v27. Over the pas...
Not sure where we downloaded the object, but the elevation view is
reversed from the plan view. I don't know GDL, but guessing/hoping its
an easy fix in the code somewhere. Can someone help? TIA
I'm reworking our template favorites for cabinets to incorporate new
features of AC25. Perhaps I haven't found it but can you:1) show dashed
lines indicated door swings and shelving behind the doors in 2d
elevations2) at a two segment base cabinet, w...
Looking for advice when bringing in a structural engineer's revit
structural model as an IFC hotlink module. With myself never using Revit
and my P/E never using Archicad. how do we go about understanding the
translators? Although we got it worked ou...
I've brought in a Revit Structural model via IFC as a hotlink module.
After some back and forth translation issues between Revit reference
planes vs Archicad Stories I think we have it. However, as a HLM I
cannot adjust pen colors. I can do this with...
Thank you @Laszlo Nagy . We'll try the IFC viewer. We've experimented
some more and it appears the design options are the common denominator.
Once we merged and relinked to the main model the IFC was able to open
in Revit. We've started a support tic...
What are Graphisoft's plan to support continued development of BimCloud
Basic? For those of us on SSA that are successfully using BimCloud Basic
for teamwork projects I see no reason to 'upgrade' to subscription
unless we are forced to use BimCloud S...
I'm having similar syntax error as reidweber. Hoping to open the thread
again to find a solution. Rather than /12 I would like to put /1'-0" at
the end of the expression. Would that be .... /1\'\-\0\"")
