Composite wall ends and corners not showing proper line weights!!!

[Abdullah Chaus]

The end lines of my composite wall section at corners and ends do not have proper line weights. I have tried searching all over the internet and everybody says to make the composite section's pens equal. Well, I did that but it's still not working. Please see the attached screenshot. Also, I have 'Both' options turned on for wall end in the wall settings dialog :}

Operating system used: Windows Windows 11 Home, AMD Ryzen 5 5600H with Radeon | 3.30 GHz | 24.0 GB RAM

[Barry Kelly]

In you wall composite settings, each skin has an option to show the end lines.

Try turning those on.

Barry.

[Abdullah Chaus]

I already tried that but no luck 😞

[cuba]

Are the walls connected with non visible walls/uncut walls? 

Set the floor plan display to projected with overhead.

 

[Abdullah Chaus]

There were some hidden elements. And I deleted them but only part of the wall end turned into the proper lineweight. One end is still problematic. And I set the Floor Plan view to 'Projected with Overhead' but nothing happened...

[Barry Kelly · Accepted solution]

Judging by the angle on the corner, the wall is interacting and trimming with another wall in a hidden layer.

Barry.

[Abdullah Chaus]

Yep, that was it. It was a beam, not a wall, though. Thanks a lot