- last edited on by
Laszlo Nagy
I don't know why I can't increase the marker size through the dimension selection settings. It's limited to 100 mm:
2 ACCEPTED SOLUTIONS
Accepted Solutions
@Martin Jules wrote:
(scale: 1:237 on the layout book):
So, are you placing a view on the layout and then re-scaling it in the layout?
This will cause problems.
You should create a view at the scale you want.
Adjust annotation size (including dimension markers) to be the size you want to print them (i.e. 2mm text, 4mm text - what ever size you want the annotation to print as).
Then place the view as a drawing on the layout at 100% size.
What you see in the view is what you will see in the layout.
If you open your drawing (open source view), what is the size if the dimension text and marker size?
And what is the scale of the view?
Barry.
100 mm is too small compared to the size adopted at my work which is possible from other BIM software for example:
I don't understand why you want it so big.
It will print on your page as 100mm - is that hat you want?
Barry.
Here's an example from ArchiCAD:
I can't find what they need from ArchiCAD.
Are you wanting to change the length, or the thickness?
the setting you are changing is the length, the thickness is controlled via pen setting.
Still looking?
