Elbow Factor Radius

[Hilario Bourg]

In case of a large duct (1320 x 220) the elbow curve is too large: factor radius can't be set less than 0.6.

It seems that Archicad reads the widht as it were the height and sets the curve consequently.

[joaopina]

Same problem here

[joaopina]

In the Route Preferences, archicad has a table for Duct Rigid that is splited with rectangular shapes and circular shapes, but the table for elbows is only considering circular shapes. I hope that Graphisoft has corrected that issue before the launch in this october.