Informationen zu Noody

Noody · 2025-07-07

Hi guys, After an hour of searching on the forum, the problem I have, i couldn't find the solution or an article about it. But my question is, is there any way i can make two different roof materials? In the image attached, inside the house theres gonna be Gypsum. But on the...

Noody · 2025-07-05

Hello everyone, I have a question about cutting beams at a specific spot. Is there any way I can cut the beam at a specific spot, as shown in the picture? I need to make a custom truss for the roof, but also for the project plan, i need to have that cut part on the timber so...

Noody · 2025-07-02

Hi,I have a problem in Archicad where I'm unable to make the bottom and top wall finishes wrap evenly over the door side faces, the same way they do on the front face of the wall.I've attached some screenshots of the wall and its modifiers for reference.The wall is composed ...

Noody · 2025-07-17

Try updating your graphic card drivers to the latest ones. Go to Options, Work Enviornment, click Graphics. Ensure that OpenGL is selected for 3D rendering and that Hardware Acceleration is enabled. Couple more things you can check is to check memory settings in Options, Pre...

Noody · 2025-07-14

If i get you right, you want to change the opening of every single slash on multi-slash window. On image attached, you select "opening type and angle" and you have for every single sash what kinda opening type you want.

Noody · 2025-07-05

But also, whenever i want to change the size of the door or door sill height, i also need to make a new empty opening in order to achieve that?

Noody · 2025-07-03

Thanks a lot! 

Noody · 2025-07-03

This is the code i've been using. Notice for someone who is still new to all of this as me. For the object, you need to add 4 parameters and assign them Type as Surface and pick the paint you want to have for it. Also, you could use 2 more if you need for the bottom ones on ...

Benutzerstatistik

Benutzeraktivitäten

How to have two different roof materials?

How to cut beam on specific spot?

How to put two different finishes from the complex profile wall warp the door and window side faces?

Re: Laging in elevations and worksheets

Re: Changing the opening of multi sash window

Re: How to put two different finishes from the complex profile wall warp the door and window side fa

Re: How to put two different finishes from the complex profile wall warp the door and window side fa

Re: How to put two different finishes from the complex profile wall warp the door and window side fa