I have a interior elevation rendering issue happening with BIMx. The
tile image used for the elevations renders fine when looked at in
ArchiCAD, published pdf's, and even in the BIMx 3d fly through model.
However when you go to the BIMx interior elev...
I'm publishing a BIMx set and one drawing hangs the upload and doesn't
publish but allows me to stop the upload. The file that won't upload has
it's status as pre-processed. I've tried deleting the document and
reloading it but it still doesn't work....
When I go to publish any document I get a pop up warning that :As a
result of the last operation, some stairs have become invalid, will be
shown with a color highlight and I can use the built-in "Invalid Stairs"
criteria set to find it.Except none of...
I am cutting sections through my model and the complex profile beams are
all cutting with the same black pen (1?) and I can't find where to
adjust it in the beam settings, section settings, model view options,
graphic overrides, or renovation filter....
I swear I have done this typical window before with the ArchiCAD library
but for the life of me I can't figure out how. A long time ago I used
the Smart Parts window which is shown on the left but I haven't used
that library for a while now. The best...
Good specific advise here and now for some more general advice.Don't
feel bad about hating the software for the first couple of weeks, that's
human nature and it's not the software, and don't waste everybody's time
by complaining about it. I used to ...
To update everyone, this is a known issue that will be fixed in AC27.
Here's the current workaround.As a cumbersome workaround, you can create
two different textures for the distorted and for the non-distorted
appearance. make a copy and rename the "...