Wall End - cut outline error

[Zendrix]

Hi!

Im having an issue with a wall end in a simple composite wall made of plaster/brick/plaster. As you see in the pictures, the line thickness (exterior contour) is interrupted at some point in this wall end. Im not sure what i am doing wrong.

Thanks,

Z

[Lingwisyer]

Would it not be better to use the Wrapped End type instead?

[Zendrix]

Thank you Lingwisyer, that was it. I have another problem now, though, which is that i cant make only the exterior line thicker, when i choose a thickness, it applies it to both the outline cutline and the interior brick line ending.

is there any way to make that happen?

Thank u!

Z

[Lingwisyer · Accepted solution]

Unless you are wanting it to use different Pens to the rest of your wall, you should just be checking the toggle "Use Wall's Contour Pen" ("Usar a Caneta de Contorno da Parede" I would assume), then it will just use the Pens matching your Composite.

Ling.

[Zendrix]

I tried that before, but it uses a grey pen on the brick, i dont know why...

Thanks

Z

[Lingwisyer · Accepted solution]

Do you have Wall End Lines turned on for the brick layer of your Composite?

[Zendrix]

That was it Lingwisyer, my composite had the brick with a greyish line for the wall end.

Thank you very much!