About wkrt-hs

wkrt-hs · 2024-04-23

Hi!I'm trying to find the right settings for a label used for automatic labelling.But no matter what settings I use, the angle of the pointer always changes to something weird.On the left is the manually set label, which I then use for automatic labe...

wkrt-hs · 2024-03-12

I am creating a roof in Grasshopper based on anchor points of columns in AC.When I move one of the columns, instead of updating the existing roof, it creates a new one. This results in a new GUID and loosing all solid element operations / placed wind...

wkrt-hs · 2023-12-05

Hi! I just discovered that the top skin of a composite skin is never pulled into an opening. No matter of changing the z-position or type (core/finish/other). Both slab materials have lower priority than the wall material.Also, if I change the remain...

wkrt-hs · 2023-11-06

Design options in AC 27 raise hope to solve a longstanding challenge in hotel/housing projects with repetitive room or apartment modules.Usually, over time, there are more and more variations within modules that were the same in the beginning. For ex...

wkrt-hs · 2023-10-17

In most of our projects we have duplicates of attributes with an appended number like (1).In some projects, they even extend until numbers like 20 or so. Most of those projects are teamwork projects and use hotlinks.No matter how we try to reproduce ...

wkrt-hs · 2024-03-14

This is a minimal working example:I have four columns in Archicad connected to GH. When I move them, the roof is recreated and not refreshed, thus it looses for example it's windows and gets a new GUID.I'm not sure if this is the expected behavior, b...

wkrt-hs · 2024-01-09

Das Thema kommt seit Jahren immer wieder auf, aber es scheint leider noch keine Lösung zu geben.

wkrt-hs · 2023-12-11

Thanks for your response, George. I'll see if I investigate further, but it's good to know that it's probably nothing related to my python environment.

wkrt-hs · 2023-12-05

It's literally the 3 lines from the first post that already fail.Are you able to build and run them successfully in your environment?

wkrt-hs · 2023-12-05

Apparently there's a registry setting allowing you to only refresh certain HLMs of the same source:Solved: Re: Teamwork Performance of multiple self-referenc... - Graphisoft Community

User Statistics

User activity

How to set Label Pointer Angle for automatic labelling?

Updating existing Roof Components instead of creating new ones on update in Grasshopper

Wall-Opening - Composite Slab: Behaviour of first skin

Using Design Options for Small Variations of Repetitive Hotlink Modules (Hotels etc.)

Where do duplicate attributes (1) come from?

Betreff: Updating existing Roof Components instead of creating new ones on update in Grasshopper

Betreff: Top Stempel auf Nachkomma Rundung der Raumstempel anpassen

Re: Compile Python Scripts to Executables

Re: Compile Python Scripts to Executables

Re: Updating a single hotlink and not every hotlink in the entire project

Archicad AI Visualizer