Hi,I can't come up with a solution via searching....maybe not entering
the correct terminology. I have two slabs. One is the concrete floor and
the other is the column footing. The top of the footing is just below
the slab so I put both on the same s...
Hello, I have been using the Out of the Box Room Finish Schedule from
GSNA 26 on a project started in 25. The Interactive Schedule would not
allow me to edit the fields in the schedule for Wall Finish until I
updated the Zone Stamp from a 25 to 26. I...
Hello,Searching has not turned up an answer for me on this one. I am
involved in a lot of residential renovations.Exterior walls are either
older solid brick masonry or wood frame construction. What usually
happens is the main load bearing walls are ...
Hi....I am NOT an IT specialist....so I may have made some mistakes when
installing AC26 and Ventura. Last Fall I installed AC26 on the previous
macOS. Then a week or two ago I upgraded to Ventura. After upgrading I
noticed that switching between pla...
Hello. This is for Archicad 25 NA. I have used the window object Splay
Bay 25 in a house model. It seems it only has options for the main
(middle) pane to have some sort of opening. I cannot find a way to
select "not operable". That is, have all wind...
Hello Laszlo Nagy,thank you for the detailed reply. I see some degree of
manual work is involved. I will look at putting the structural footings
on a different storey and this should help. Have a great day! Grant
Hello jl_lt Thanks for the reply and sorry for the delay. Just getting
off vacation mode!I understand all of your suggestions. I suppose the
footings should be on a separate storey (Foundation Plan). This should
solve the challenge. Thanks. G