In 3D projection settings we can set view angle (cone) to the maximum of
120 degrees. This may seem like a lot, but honestly, for inspecting
interiors it's not too much. I'd like to set it to 150 degs. Can we
maybe change this value in registry or in...
Hello,The default behavior when placing windows in curved walls in that
window jamb is perpendicular to the wall baseline. You can see such
situation in the left window in the screenshot below.But I need to have
jambs parallel to each other, like it'...
Hello,I have a problem with a specific model from which I extracted two
walls, built with the same material, on the same layer and storey, with
base lines connected, but:The side (edge) surface finish of the thicker
wall doesn't get overridden, and y...
As in the title, sometimes, I cannot drag a guide line over 3D
viewport.Whether this issue occurs or not, depends on camera position,
and it seems like I cannot drag it when camera is too close to 3D
geometry (elements). Zooming out solves the proble...
Hi! I am trying to import a point cloud (E57) in a simple model, but
Archicad fails and throws an error that I will try to translate to
English: "Failed inserting object of point cloud KRYSIEWICZA... Press
NEXT to continue or Quit to abort." The mode...
By "legacy drawing", do you mean whether it was previously saved in an
older version of Archicad? No, as far as I know, it was created in AC 25
POL and always saved in this version. As you said, it might be the
easiest thing to just redo those parts ...
Yes, my situation is just as yours - new walls in the model will be
covered with surface paint, as expected. There were multiple spots in
the original model with this issue, but unoftunately, I'm not allowed to
share the whole model.
You mean this setting?I can't see a relation between this issue and wall
intersection group number. No matter how I change intersection numbers,
the thick wall will retain its side non-painted, while a new pair of
walls like these will "behave proper...