Hi, When I first started drawing walls, a circle would appear at the
first point/corner of the wall, but suddenly they are not enabled. How
could I enable them again? ThanksThe smallest circle at the "pen cursor"
Hi!Yes, when I open a new project file and I chose the "default
template", the circle and the lines appear. But that means I have to
redo all if I cannot figure it out the problem.
Hi!It does nothing when I use the "Q" key when my cursor over the point.
I also checked my work environment for the delay until Snap/ Snap Guides
and it is set for 1 second.But what does it mean "working far from the
AC origin then it may be the guid...
Hi! Yes, my snap guides are on, in fact they were enabled since I
downloaded Archicad, but I really don't know what is going on with them.
I even tried to downloaded it on another PC and I have the same problem,
even if I didn't modify something. (ph...
Hi!I had a look over that online help with the snap guides, and still it
doesn't show me that little blue circle and the dotted lines that helped
me make the walls. Moreover, I have just found that I have another
problem. When I try to make a wall, i...
