Greetings Everybody, Visualization and the visual language as a whole is a crucial phenomena when we communicate our ideas to the clients. Should that be vectorial, artistic, non-realistic, photo-realistic, 2D or 3D from classic quick shaded represen...
I'm new to using the Revision History Object. I have added it to the master plan layout, have linked all changed to the appropriate wall etc but changes will not show in this table, even though I can see them in the project Indexes change list. Have ...
Hello, I am trying to do an elevation of a pitched roof. Is it possible when you are in an elevation to add an elevation viewpoint with the same angle as the pitched roof? Why is it possible to add an elevation viewpoint when you are in an elevation ...
Hi - I was wondering where the data on the energy source factors is from? Is it generic or location based?Thanks in advance
Latitude and Longitude input not accepted: example 9.79744500 not accepted and 9.49744500 substituted, a similar problem with longitude.SOLUTION:switch button to digital but do not type in number as that will not work. Type the digital number in Word...
This is a scenario that pops up for us constantly and is a problem Graphisoft should really explain why they don't address this issue. Model a short or multi-story wall on a "lower story" tall enough to show up in the cut plane height illustrating al...
Hello to all i have the following problem. When I go to print the print tool looks like this and there is no way to change it. Thanks
I am using my own template and have nearly finished some working drawings with it. However, I want to change the template to the standard Australian template for the existing drawings. Any sugestions to make this easier would be appreciated.
I hope I am just missing some obvious technique or setting - but for the life of me I can no longer seem to drag a bunch of saved views from navigator list at once to the currently showing layout. I can drag a single saved view onto a layout, and it ...
I am finding that the door thresholds are showing up transparent in the plans and I can see the floor finish running across the door opening just fine. and the Zone colors as well. When I change to RCP and shut the door symbols off. The heads do the ...
Hi all, I'm waniting to get the walls showing above on a set of plans. I've setup the walls to have all the correct settings. Now, the wall with the red arrow to it is the problem, i want to dispaly the frame & brick. same as the wall adjacent to it....
