cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
Document & Visualize forum

Forum Posts

wheelchair accessible route representation

Hello,I have a question about wheelchair accessible route representation like it`s in the picture. (it`s mandatory to show the route in my country in some spaces). Currently I am using the fill tool for this purpose. Is there any smarter way for this...

Renovation - window hole/niche issue

HiI have a problem with placing the window in place of an old one. They are both different shapes and sizes. In order to make an existing window hole (or rather niche) I had to create a morph that would substract the wall with the solid element opera...

Door element id with 0

In attached screenshot 01, there are 3 doors shown with element ids 6, 6a and 6b. in door schedule, all 3 doors are visible under different headlines. But, once we change element id of door from 6 to 06, the remaining doors 6a and 6b also gets clubbe...

Survey point in AC 23

I've started looking into the use of survey-point in AC23. I've modelled a compass, to make it easy to see what is happening. Immidietly I see this in Zoom:The blue compass is with the default values set, that means that true North is set as 90°. How...

Kamelite_0-1664459038169.png Kamelite_1-1664459186532.png

Export IFC-Translator Settings

Dear Community, Archicad has an IFC Translator and I was wondering: Where are those translator settings saved?On the official site I found following:https://help.Graphisoft.com/AC/23/INT/_AC23_Help/115_IFC/115_IFC-24.htm#XREF_54387_Important_Note_on"...

Dayiz by Booster
  • 312 Views
  • 4 replies
  • 0 likes

Resolved! Tracing over a trace refererence

I am having to draw over PDF plans to create copies. I've set the PDF dwg as a trace reference so that I can draw over the top of them using the Archicad wall, door, window, tools. But I can only use some 2D tools such as lines and circles. If I try ...

KeesW by Advocate
  • 281 Views
  • 4 replies
  • 0 likes

Revision ID

I created a duplicate view on a separate sheet. The first image shows the correct revision bubbles. But when I duplicated the same exact view in another sheet the revision ID change completely. This is the numbers that should show up as revision IDs ...

MicrosoftTeams-image (4).png MicrosoftTeams-image (5).png