Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

COLUMN, BEAM, AND WALL BEHAVIOR

I know there must be a trick to fine tuning the column, beam, behavior when using with a wall. What happens: I detail out a wall with a beam, and 2 x columns. When used, they cut out the space in the wall. The result is my elevations show the notched...

Anonymous by Not applicable
  • 278 Views
  • 2 replies
  • 0 likes

Resolved! Break morph union

Can a union of morph elements be broken afterwards? If yes, how is it done? Thank you!

Anonymous by Not applicable
  • 224 Views
  • 1 replies
  • 0 likes

Resolved! Tube with different inner and outer section and holes in it

Which tool would be best to use to create this tubular shape with different inner and outer section and then cut ellipsoid holes along its length? As far as I understood, shell tool could easily cut holes in the tube, but morph tool couldn't. Thank y...

Anonymous by Not applicable
  • 299 Views
  • 5 replies
  • 0 likes

View selected items in several viewports

Hello! I have one question related to selection of items. I am working simultaneously in 3 viewports (floor plan, section and elevation) and I was wondering if it is possible to view a selected item (from ground floor) also selected & highlighted in ...

Anonymous by Not applicable
  • 123 Views
  • 2 replies
  • 0 likes

Resolved! spheres' intersection

Hello! How can I intersect two spheres? Meaning I want to lose these two dark grey parts. Thank you!

Anonymous by Not applicable
  • 125 Views
  • 2 replies
  • 0 likes

Resolved! Location of picture referenced with index

Hello, I have a model I need to modify with a ui_pict_button in the Interface script, where the picture_reference is an index, as shown below ui_pict_button ui_link,"text", 1, 300,0, 100,30, 1, "www.somewebpage.com" UI_TOOLTIP "Click to open webpage"...

Anonymous by Not applicable
  • 385 Views
  • 2 replies
  • 0 likes

Resolved! Trimming a sphere to a wall

Hello! How can I trim a sphere to a wall or a shell. It should look something like shown on the attached image, only without the slab. Thank you!

Anonymous by Not applicable
  • 288 Views
  • 3 replies
  • 0 likes

Resolved! Gap appears when trimming two vaults

Hello! Does anyone know how to trim the vault going from left to right, completely to the vault going back to front? Since the vault going back to front is not a half circle, but more of a circle cut somewhere on its bottom, when I use the command 'T...

Anonymous by Not applicable
  • 252 Views
  • 3 replies
  • 0 likes

Didn't find the answer? Start a new discussion

Labels