Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

complex profile update

Hello. I have an issue regarding complex profiles. I draw one and use it. However, when I edit and therefore change it, it does not update. The elements already in use do not have the new attributes and I need to draw them all over again. Does anybod...

Anonymous by Not applicable
  • 1707 Views
  • 3 replies
  • 0 likes

Split into single plane roofs... not possible?

I have created some roofs on AC17. Trying the edit-split into single plane roofs.. and it simply deletes my roof.. Is that a bug? There was not such a problem on older versions. Also I opened the file in AC16 and my roof also disappears after using t...

Anonymous by Not applicable
  • 2045 Views
  • 0 replies
  • 0 likes

Design stair from selection with non-quadratic landing

Hi, I'm trying to make a stair using Design from selection tool. It is a basic u-shaped stair and I want a landing where the stair turns which shouldn't be quadratic (fits more steps). I've done the stair with slabs and Morph tool but that is not ver...

Anonymous by Not applicable
  • 3488 Views
  • 7 replies
  • 0 likes

A restriction of the SEO's Intersect command

The Intersect command works only with one operator. One operator can interact with many targets, but two operators cannot interact with one target. This feature is a major shortcoming of the SEO command. It requires a lot of extra work to circumvent ...

Anonymous by Not applicable
  • 1943 Views
  • 4 replies
  • 0 likes

Solar Analysis is not accounted in Energy Simulation (AC17)

It appears that Energy simulation in AC17 INT does not take into account solar analysis that was calculated for any openings in a project. Test: as soon as you add a window to a south wall (for testing purposes the only window in the project) the Ene...

Anonymous by Not applicable
  • 27583 Views
  • 27 replies
  • 0 likes

Archicad SE 13 English version

I have choose to amend this comment due to the fact that Archicad has indeed developed an English version of Archicad 13 SE and it performs well. It answers the following complaint that I posted earlier! This new version is worth getting in my opinio...

Anonymous by Not applicable
  • 2858 Views
  • 1 replies
  • 0 likes

Problems with editing plane

See attached. Editing plane display is turned on, yet the options are greyed-out on the toolbar. Also, the editing plane does not display in the 3D window. Frustrating, because I'm trying to use the morph to create fascias but it's tricky without the...

Jere by Enthusiast
  • 1723 Views
  • 2 replies
  • 0 likes

Zone

Ok guys, need your help (and I'm sorry for my poor english, I hope you will understand my problem:)); I'm working with zones now and what I need is to get two measured values : "normal" room area and room area without wall finishing.Any possibilty to...

Anonymous by Not applicable
  • 853 Views
  • 1 replies
  • 0 likes

Didn't find the answer? Start a new discussion

Labels