Documentation
About Archicad's documenting tools, views, model filtering, layouts, publishing, etc.

Forum Posts

Resolved! Custom Line Type Reference Line Justified to One Side

Does anybody know how to create a custom, asymmetrical line? I.E., when I draw the line, I want the symbol to be justified to one side and not centered on the custom symbol created. There is a stone symbol in Archicad which does this, but I cannot fi...

Screen Shot 2022-07-27 at 3.08.27 PM.png Screen Shot 2022-07-27 at 3.08.38 PM.png
EH21 by Booster
  • 870 Views
  • 9 replies
  • 0 likes

Resolved! Problems placing View on layout

I am having the following problem with both AC 25 and AC 26. Saving a view or placing level from Model space to layout book changes the colors of it. When i check the view settings of the drawing in the layout book everythin is correct. Even if i try...

Resolved! Door Leaf Thickness on 2D Plan

Hello! Is there a way to show the door leaf's thickness on the plan? Instead of 1/4 of a circle symbol, I'd like to see the leaf. Without having to manually adding a 2D Rectangle Thank you to anyone who can answer!

image_2022-07-27_130006569.png
fowebe by Contributor
  • 683 Views
  • 3 replies
  • 0 likes

Cut Fill Pen Thickness

How can I change the cut fill pen thickness of materials in a composite? See image. The two circle areas are the fill hatch of a building material that the line thickness is too large. The fill where the arrow is pointing is what is desired. I create...

Resolved! Twinmotion in Archicad 26

Hi Everyone, I've only been using AC26 for a week or so, on a single project but I can't find any information on how/if Twinmotion is actually supported in Archicad 26. I know there's some new feature for an app called Enscape (or something like that...

joelsdg by Enthusiast
  • 18853 Views
  • 64 replies
  • 3 likes

Door schedule, Nominal vs Rough openings

Hi Archicad community!I need an explanation on how to get nominal and rough door openings for my door schedule. These are the main two parameters that I need, and I struggle to make my schedule reflect the actual door sizes. Besides getting the actua...

Simple clean DWF\DWG 2D export

I want to get a simple DWG\DWF export that will produce a clean 2D output, with no overlapping lines and fills, no fills except cut fills, no wipeouts. Just what you would get if you'd print your layout on paper. No hidden geometry or solids. WYSIWYG...

BAU by Contributor
  • 780 Views
  • 5 replies
  • 1 likes

MARKERS FOR DOORS ARE DIFFERENT

Hi,The settings for Door markers in model settings don't seem to control Sliding doors width (only)?(Please see attached)I added a marker to Sliding doors inside the settings for individual door settings.

cadsph by Enthusiast
  • 292 Views
  • 1 replies
  • 0 likes