Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! RHINO 7

Hi, I can see that Rhino 7 doesn't recognise ArchiCAD live connection. Is there a way to make it work or how shall I do it? Frank

Anonymous by Not applicable
  • 10348 Views
  • 29 replies
  • 0 likes

Not Able to Change Units

I have a metric project. I created a unit profile in centimetre in Dimensions in Project Preferences and changed to it. However, after I switched between different views for two to three times, the units changed back to the decimal feet. No matter ho...

Anonymous by Not applicable
  • 294 Views
  • 6 replies
  • 0 likes

Resolved! collide at wall intersection

Hello, When I draw two walls with different type and intersected each other, some material penetrate into the other wall, and the method of material priority seems not to be an easy way (because so many material type...) Please advice Thanks

Anonymous by Not applicable
  • 144 Views
  • 2 replies
  • 0 likes

Problem with Goodies Wall Accessories

I was trying to use Wall Accessories to model wall framing. I closely followed the tutorial: 1) Select the needed walls; 2) Design -> Design Extras -> Accessories -> Wall Accessories; 3) Choose Wall Framing 24; 4) Set parameters; 5) Click OK; 6) Clic...

Anonymous by Not applicable
  • 334 Views
  • 2 replies
  • 0 likes

Resolved! problem: slab and beams' lines don't intersect

valarhi, i couldn't solve that, used all my weapons still these lines showing, didn't understand. it should be solved. this line shouldn't show. checked: *they are in the same layer both with same number of intersection. *they are with same material....

Resolved! problem at wall corner

Hello, When I draw wall enclosure: (1) whilst when draw wall enclosure on a blank space, it fillets normally. (2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply, Please advice why, see picture abo...

Anonymous by Not applicable
  • 358 Views
  • 8 replies
  • 0 likes

Floor plan view beam

Hello, I would like to know how to show the entire contour of my beams. I have use them to reproduce the roff ridge (corniche) of an old school from the 40's. That corniche has gables. I would like to see lines in floor plan view where my beams are i...

Anonymous by Not applicable
  • 263 Views
  • 3 replies
  • 0 likes

How do I control how a door is assigned to which zone?

There is a zone on both sides of my doors. The door schedule reads one of the zones, but it does not seem to be the zone that has the door tag location or the door swing direction, and yet sometimes it is. I have not been able to figure out how to co...

Didn't find the answer? Start a new discussion

Labels