Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Archicad and Grasshopper troubles

HI everyone I have installed Archicad 25 updated 2 and rhino 7 in my Mac but at the moment that I try to work with the connection I have no respond for example if I choose slab in the parameters section in GH, put the icon in the canvas and try to se...

Texts turns in grey rectangles

Hello!I have the latest Archicad 25 version, and I have a Macbook Pro 14'' laptop with the new M1 pro chip, and I have a problem with my Archicad projects. When I zoom out my 2D plans, the text turns into grey and unreadable rectangles, and I haven't...

mm_v by Participant
  • 218 Views
  • 2 replies
  • 0 likes

Walls Disappear Immediately After Drawing Them

I must have set the project up incorrectly as every time I draw a wall it disappears. I draw it on the Ground Floor and it only appears on the 2 Story. I've tried adjusting every setting to get the wall to show on the Ground Floor but to no avail. An...

Miner by Contributor
  • 210 Views
  • 2 replies
  • 0 likes

Resolved! How to remove grey shaded areas from doors?

I just switched from Archicad 19 to Archicad 25 so a lot of things are new to me. But one thing I cannot figure out is how to remove this gray shaded area (also what is it for?) from the doors. Does anyone know how to do this? Thanks

Screenshot 2021-12-10 at 11.14.25.png
ER by Newcomer
  • 433 Views
  • 2 replies
  • 0 likes

3d presenation in Archicad

Hello guys, is it possible to do something like this in Archicad. Is this vector from Archicad or? And about this elevations, is this possible in Archicad? Best regards.

Mr_X by Participant
  • 306 Views
  • 3 replies
  • 0 likes

Beam Intersections Not Cleaning up

I am using the Beam Tool to make footings and the intersections will not clean up. They are all at the same elevation and the setting is on to clean them. They all are flat and level. I don't usually see this problem. All of the endpoints are connect...

Screen Shot 2021-12-09 at 11.22.02 AM.png

Resolved! Walls different in 2D and 3D

In one part of my model, I have three walls which looks perfectly fine in 2D (see screenshot, the selected walls), but when I switch to 3D the two thinner parallel walls are suddenly sticking out on the other side of the thicker wall (see screenshot ...

BarryKelly_0-1639099769999.png BarryKelly_1-1639099781494.png
DangCad by Contributor
  • 359 Views
  • 3 replies
  • 0 likes

Resolved! Why it is so hard to select objects in Archicad ?

Hi ! How can I select objects with magnet icon (for move), maybe some hotkey like "Q" when snapping, in other words to make magnet appear when I want and not search for tiny areas inside objects to make that magnet finally appear.I don't see a logic ...

kosta by Booster
  • 572 Views
  • 6 replies
  • 0 likes

Point cloud LAS file

I have received .LAS point cloud file, how can I convert it to .e57 or .xyz file to be usable in Archicad. Ivan

Didn't find the answer? Start a new discussion

Labels