Design forum
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Composite not intersecting properly

Hi, I'm having an issue with a composite floor slab interacting with a footing. The footing consists of a simple slab with a "Structural Concrete" material. The floor slab is a composite with a 4" "non-structural concrete" material and a gravel fill....

Footing-1.jpg Footing-2.jpg
Jere by Advocate
  • 591 Views
  • 3 replies
  • 0 likes

Door bug when wrapping around frame

Hello all, I've somehow created two distinct doors and cannot find the difference in the settings between the two. The only difference I see is that the rough opening on one has an oversize and the other does not. Other than that the two doors are id...

Screenshot 2021-10-22 110722.jpg Screenshot 2021-10-22 110518.jpg

Best story to host 3D topography

Hello everyone!What is the best story to host 3D topography? Currently we are using our ground floor story (Level 0). This is fine but has a bit of risk, because if we change the height of the ground floor level it will also move the 3D topography. W...

Nik by Contributor
  • 580 Views
  • 12 replies
  • 1 likes

Most Challenging Model of My Life

Hello Community, We all know how designing and modeling is happening: We have a great idea and it makes us happy. Immediately we realise the geometry is pretty complex, or at least, nowhere near obvious how to model it. Panic! Let's do some research ...

Resolved! AC24 vs AC24EDU

Hi,as I have both, EDU and professional license, it sometimes creates problems. For some reason EDU likes to start all CAD related projects.Problem is, when I was trying to recover project in PROF version, it starts to run in EDU version.How can I re...

HannesL by Participant
  • 488 Views
  • 5 replies
  • 0 likes

Stringer too long

Hi there !I'm completely new here and this is my first Posting. I'm an architect from germany and I will start a new Job in a new firm using AC25 on Nov. 1st. Actually it is a Real Estate firm and I will be the first architect there, so there is nobo...

Image1.png
Toshi by Contributor
  • 441 Views
  • 3 replies
  • 1 likes

Resolved! Eave attached to side edge of sloping roofs

Hi, I created eave for a side edge of sloping roofs as showed in 1st picture, the problem showed in red circle, so I made a section to change angle of eave up to 15° as same as roof pitch as showed in 2nd picture. Then the eave and roof edge was alig...

Snipaste_2021-10-20_21-29-08.png Snipaste_2021-10-20_21-34-04.png Snipaste_2021-10-20_21-35-34.png

Hotlinked models - Cut additional element - wall openings

Hello everyone!I have encountered a problem and I need some help Here is the description:I have two models:Structural model - contains RC walls, slabs, foundation, columns etc. Basically, model contains only structural elements and defined wall/slab ...

Klik by Contributor
  • 705 Views
  • 11 replies
  • 0 likes

Few issues with Archicad

Hi, I worked whole time in Archicad full version and switched to Solo 24. All environment is deleted - Including Shortcuts (that I had to add manually), and some - like arrows down, up, left, right are not even there in option to set up, therefore, I...

sedamr by Participant
  • 206 Views
  • 1 replies
  • 0 likes

Didn't find the answer? Start a new discussion

Labels